|
How To Lay Bathroom Floor Tiles ? |
|
Written by Scott Rodgers
|
|
Saturday, 12 December 2009 08:43 |
|
If you are planning to change the tiles of your bathroom then it is not a difficult task to do. All it wants is proper use of tools and knowledge of using them. There are countless choices of tile designs and types that you can use to update your bathroom. Two most common choices are glass tiles and ceramic tiles. If you want to install a glass tile then you just need to insure that they are rated for floor use.
by ScottRodgers
If you are planning to change the tiles of your bathroom then it is not a difficult task to do. All it wants is proper use of tools and knowledge of using them. There are countless choices of tile designs and types that you can use to update your bathroom. Two most common choices are glass tiles and ceramic tiles. If you want to install a glass tile then you just need to insure that they are rated for floor use.
You need to have proper tools for this job. The basic tools include: cutters, tile nippers, grout, a large sponge, grout spacers, and a notched trowel. If you are installing sheet tiles then you don't need the grout spacers. Sheet tiles are very easy to install as they come in ready to install mosaics.
Before starting the process you need to remove old tiles from your bathroom floor. It is little cumbersome to do. Once you have removed old layer, properly clean the surface so that it becomes smooth and ready for next layer. Use grease cleaners for removing extra grease from the surface.
Measure the space properly before ordering tiles. Always order extra tiles than required because you can do mistake in calculation or some of the tiles may break during replacement process. It may become difficult for you to get same color of tiles again in future as tiles come in dye lots and there can be obvious differences between two same shades of tiles from different lots.
Remove all the molding and fixtures like the toilet or sinks from the bathroom. You also need to purchase subfloor, either green board or cement board and screw it to the floor. It should be cleaned and leveled.
Now you can start fixing the tiles on floor. It is preferred to start fitting from the longest wall side as it makes your task convenient. Use rubber mallet for tapping as it fixes tiles well onto the floor. After that, grout spacer is used to maintain equal space between the tiles. If you need small tile for any place then you can cut a tile with tile cutter.
Leave tiles to set for 24 hours. After that you need to spread grout into the spaces between tiles with help of trowel. Wipe off excess grout with a wet sponge. Next day, run a damp mop over the tiles to clean off any additional grout. Let the grout cure for few days before stepping on the flooring.
Once your new bathroom tile is cured you can reattach the fixtures. Keep the extra tiles for future needs. You are now ready with new bathroom floor.
About the Author:
Scott Rodgers is a noted author who has been providing ample guidance on plumbing works all across the nation. His expensive knowledge has, in fact, sparked significant rise in revenue for talented plumbers across the nation, from Blountstown Plumbers to Mc David Plumbers . |
